It is currently Wed Jun 20, 2018 5:38 am

All times are UTC


Post new topic Reply to topic  [ 11 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: Sun Feb 18, 2018 4:48 pm 
Offline
User avatar

Joined: Fri Aug 28, 2009 9:16 am
Posts: 28
Location: LANCS
Ohlins damper lengths & spring rates
Easiest way to tell is to simply measure the dampers (measurements are centre of the top end eye to centre of bottom end eye)

Exige 240 & pp

Front 337mm/57nm
Rear 414mm/74nm

Exige Cup 260 -

Front 327mm/80nm
Rear 404mm/105nm

2-11 std ( i think the 211 has shorter length wishbones too)

Front 316mm/80nm
Rear 384mm/105nm


Picture shows 260 cup springs with locking collars set at std ride height for 240 springs. The cup springs are shorter both front and rear.


To convert a set of 240 shocks to 260 spec it's valves, shock length & springs. I need to get my shock lengths sorted, so i can run a lower ride height.


Attachments:
Photo 09-10-2013, 17 15 44.jpg
Photo 09-10-2013, 17 15 44.jpg [ 817.82 KiB | Viewed 412 times ]
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 11 posts ]  Go to page Previous  1, 2

All times are UTC


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group