Page 1 of 1

fitting TC to the S1

Posted: Wed Dec 05, 2018 5:45 pm
by s-express
Ok, so I'm going to skip my VAG ecu and fit a DTA S80 pro, this will give me the ability to use a quite sophisticated TC option.
No problem fitting rings and sensors on the rear hubs - but the front looks a little more complex - has anyone done it? And if so, HOW???

Re: fitting TC to the S1

Posted: Wed Dec 05, 2018 10:46 pm
by AndyD
On the Orange car Martin and Steve copied what Pilbeam did and made a new Wheel bearing washer with stakes on - you might just be able to see the sensor that was bolted to the upright to pick up off the stakes.


Image

Image

Re: fitting TC to the S1

Posted: Thu Dec 06, 2018 5:30 pm
by s-express
Nice fix :-) Thanks for that. Just need to speak to DTA to make sure the ecu will be happy with a different no of pulses from front to rear.
Cheers