Ok, so I'm in the middle or a (more or less) total rebuild. Front end done, now on to engine and box removal for overhaul. One thing I'm not happy about is intercooler position, apart from the fact that there's nowhere for the air to escape to (I will be cutting out numberplate area for this), the intercooler is also not placed very well so I would assume what little airflow does get to it, then finds it easier to go around the side of it rather than through it!
So thinking of relocating to the rear of the clam, as high and as wide and as deep an intercooler as I can make fit (as seen by the red lines). Also considering ducting all the way from the rather large side scoop, over the intercooler and then sealed nicely against the rear of the clam.
Anyone any thoughts on this?
Did consider going the charge cooled route but I reckon this will be simpler and at least as effective.
Cheers
Alex
