Page 1 of 1

Wishbone Bearings spacer refitment

Posted: Mon Jun 29, 2020 3:52 pm
by gripster
Starting to rebuild now and refitting the swing arms complete with ES bearings.
So when refitting the arms I take it the snubber is left out from the front and a small washer is put in its place? Keeping the original washer config as dismantled at the back of the arm? Strangely 4 on nearside 3 on the offside. Will get Geo done (suggestions for south of Bristol please :thumbup: ) but want it secure and solid for the drive there. Thanks in anticipation